Hello David,
I've spent many hours to make my 2 Fritz PCI v2 work with Asterisk :-)
I was not able to make them work with the fcpci drivers (even with custom driver modifications).
The solution was to use mISDN (with chan_capi) instead of fcpci.
You have a guideline at http://rcum.uni-mb.si/~uvp00845b/
However, there is a caveat : when installing the avm driver, use the special following syntax, otherwise the 2nd card will not work : insmod avmfritz.ko protocol=2,2 type=28,28
Hope it helps,
Olivier
David Phelan wrote:
Hi Everyone,
Long time reader, first time poster.
FINALLY got my First AVM Fritz Card up and running under Centos 3.4
Installed the second....modified the drivers etc as per the instructions found at the wiki
System boots
Modprobe capi
all good
modprobe fcpci
all good
modprobe f2pci
the kernel then goes into Panic
If Modprobe f2pci before fcpci the kernel still goes into panic.
Config as follows
CentOS 3.4
Kernel 2.4.21-27.0.2.EL
fcpci - fcpci-suse8.2-03.11.02
chan_capi-0.3.5
_____________________________
David Phelan
Blue Ridge Systems
Ph:+61 7 3624 8777
_____________________________
-- No virus found in this outgoing message. Checked by AVG Anti-Virus. Version: 7.0.308 / Virus Database: 266.8.4 - Release Date: 27/03/2005
------------------------------------------------------------------------
_______________________________________________ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
