The problem may then originate from the NT of your telco ....
-----Message d'origine----- De : Altus Snyman [mailto:[EMAIL PROTECTED] Envoyà : vendredi 29 avril 2005 12:21 à : David Masure Cc : Asterisk Users Mailing List - Non-Commercial Discussion Objet : RE: [Asterisk-Users] bri error if I do a zttool it shows TE mode On Fri, 2005-04-29 at 12:14, David Masure wrote: > Did you put your card in TE mode ? > > To it seems you have configured your card to act like a NT but if you > are connected to bri telco lines, it should be in TE mode > > check in your zaptel.conf : bri te signalling > > regards > > David > > > > -----Message d'origine----- > De : Altus Snyman [mailto:[EMAIL PROTECTED] > Envoyà : vendredi 29 avril 2005 12:08 > à : Asterisk Users Mailing List - Non-Commercial Discussion > Objet : [Asterisk-Users] bri error > > > Good day all > This is a error that keeps on popping up in my /var/log/messages when I > get incoming or outgoing calls on my bri card connected to 4 telco isdn > units?It is a junghanns 4 port card with the latest version of the > drivers and latest asterisk > Apr 29 11:37:39 ccv kernel: qozap: BAD CRC for hdlc frame on card 1 > (cardID 0) S/T port 1 > Apr 29 11:37:39 ccv kernel: qozap: check the 100 Ohm termination for > this span! > Apr 29 11:45:25 ccv kernel: zaptel Disabled echo canceller because of > tone (rx) on channel 1 > > Please help and advice? > > _______________________________________________ > Asterisk-Users mailing list > Asterisk-Users@lists.digium.com > http://lists.digium.com/mailman/listinfo/asterisk-users > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users >
_______________________________________________ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users