Hi Harald, * Harald Dunkel wrote on Thu, May 12, 2005 at 01:43:51PM CEST: > Ralf Wildenhues wrote: > > * Harald Dunkel wrote on Thu, May 12, 2005 at 10:45:40AM CEST: > > > >>How can I use target-specific variables in Makefiles > >>generated by Automake? > > > > In general, that is not possible. > > For specific variables, like CFLAGS, CPPFLAGS, you may do this by using > > > > target_CFLAGS = ... > > > [snip] > > > > but for the compiler (CC, CXX, ..) this is not implemented. > > Rationale: if you change the compiler, you most likely need to have a > > separate configuration (configure, configure.ac) for it. > > Why would I need a new configure for another compiler? > AFAIR the configure script is supposed to find the settings > for either the compiler I choose, or for the default > compiler. In my case I have 3 compilers, thats all. > It should still be possible to configure these 3 compilers > in parallel.
I believe we are misunderstanding each other completely. Do you need more than one compiler simultaneously within one build tree? If not: forget my answer. If so: please explain why you would need this. Then we can discuss further. > > That may be > > achieved by using a subpackage (see Automake docs on this subject). > > This would mean that I have to manage 2 copies of the > same sources. No, that is not even true. > Hardly acceptable in a development environment. Sure. > Anyway, if I introduce a line > > myexe: some_internal_tool_used_at_build_time > > then Automake shows the same misbehaviour: It assumes that > I would like to redefine the build rule for myexe. Well, that's just how `make' syntax works (portable make != GNU make). Anyway, the discussion is moot before by question above is not answered. Regards, Ralf _______________________________________________ Autoconf mailing list Autoconf@gnu.org http://lists.gnu.org/mailman/listinfo/autoconf
