[PATCH 5/6] b43: N-PHY: correct condition blocks in init

[Rafał Miłecki]

Signed-off-by: Rafał Miłecki <zaj...@gmail.com>
---
  drivers/net/wireless/b43/phy_n.c |   16 +++++++++-------
  1 files changed, 9 insertions(+), 7 deletions(-)

diff --git a/drivers/net/wireless/b43/phy_n.c b/drivers/net/wireless/b43/phy_n.c
index d5a2dc8..356b89f 100644
--- a/drivers/net/wireless/b43/phy_n.c
+++ b/drivers/net/wireless/b43/phy_n.c
@@ -1842,17 +1842,19 @@ int b43_phy_initn(struct b43_wldev *dev)
                                        //TODO N PHY Pre Calibrate TX Gain
                                        target = b43_nphy_get_tx_gains(dev);
                                }
-                               /* TODO: If the output of N PHY Cal TX Iqlo 
with target, 1 0 as arguments is 0
-                                       if (b43_nphy_cal_rx_iq(dev, target, 2, 
0) == 0)
-                                               Call N PHY Save Cal */
-                       } else if (nphy->mphase_cal_phase_id == 0) {
-                               //TODO N PHY Periodic Calibration with argument 
3
                        }
-               } else {
-                       b43_nphy_restore_cal(dev);
                }
        }

+       /* TODO: If the output of N PHY Cal TX Iqlo with target, 1 0 as 
arguments is 0 {
+               if (b43_nphy_cal_rx_iq(dev, target, 2, 0) == 0)
+                       Call N PHY Save Cal
+               else if (nphy->mphase_cal_phase_id == 0)
+                       //TODO: N PHY Periodic Calibration with argument 3
+       } else {
+               b43_nphy_restore_cal(dev);
+       } */
+
        b43_nphy_tx_pwr_ctrl_coef_setup(dev);
        //TODO N PHY TX Power Control Enable with argument tx_pwr_state
        b43_phy_write(dev, B43_NPHY_TXMACIF_HOLDOFF, 0x0015);
-- 
1.6.4.2

_______________________________________________
Bcm43xx-dev mailing list
Bcm43xx-dev@lists.berlios.de
https://lists.berlios.de/mailman/listinfo/bcm43xx-dev