On 02/05/2010 10:41 AM, Gábor Stefanik wrote: > On Fri, Feb 5, 2010 at 4:24 AM, Larry Finger <larry.fin...@lwfinger.net> > wrote: >> On 02/04/2010 02:57 PM, Rafał Miłecki wrote: >>> --- >>> Gábor: I think you missed specs here. Could you check whole routine just >>> for >>> sure, please? I don't understand whole radio and chanspec magic yet. >>> --- >>> drivers/net/wireless/b43/phy_lp.c | 2 +- >>> 1 files changed, 1 insertions(+), 1 deletions(-) >>> >>> diff --git a/drivers/net/wireless/b43/phy_lp.c >>> b/drivers/net/wireless/b43/phy_lp.c >>> index 185219e..61009ee 100644 >>> --- a/drivers/net/wireless/b43/phy_lp.c >>> +++ b/drivers/net/wireless/b43/phy_lp.c >>> @@ -2655,8 +2655,8 @@ static int b43_lpphy_op_switch_channel(struct >>> b43_wldev *dev, >>> if (err) >>> return err; >>> lpphy_set_analog_filter(dev, new_channel); >>> - lpphy_adjust_gain_table(dev, channel2freq_lp(new_channel)); >>> } >>> + lpphy_adjust_gain_table(dev, channel2freq_lp(new_channel)); >>> >>> lpphy->channel = new_channel; >>> b43_write16(dev, B43_MMIO_CHANNEL, new_channel); >> >> Both the lpphy_set_analog_filter() and lpphy_adjust_gain_table() calls >> should be >> outside the if statement. I changed the spec a little. It used to test "radio >> enabled", but I have found that is always true for our driver. >> >> Larry >> >> > > Isn't set_analog_filter() rev0/1-specific?
It was in the 4.174.64.19 driver that I RE'd when you wrote the LP PHY code. That as changed in 5.10.56.46, which I am now doing. It will take me a while to complete the new routine "LP PHY TX Filter Init" and a routine that it calls. Certainly, there is no hurry that these changes be made. Whenever you or Rafał have time. There is no guarantee that these changes will have any effect on the LP PHY operations. Hitting a moving target is not easy. Larry _______________________________________________ Bcm43xx-dev mailing list Bcm43xx-dev@lists.berlios.de https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
