The register is not present in the bitstream. I thought that the
register was inside the dram yellow block though. I have to add it
manually or something?
Here is the listdev just in case:
['acc_len',
'adc5g_controller',
'cnt_rst',
'dout0_0',
'dout0_1',
'dout0_2',
'dout0_3',
'dout1_0',
'dout1_1',
'dout1_2',
'dout1_3',
'dout2_0',
'dout2_1',
'dout2_2',
'dout2_3',
'filter_gain',
'filter_on',
'snapshot0_bram',
'snapshot0_ctrl',
'snapshot0_status',
'snapshot0_trig_offset',
'snapshot1_bram',
'snapshot1_ctrl',
'snapshot1_status',
'snapshot1_trig_offset',
'sync_gen_sync',
'sync_gen_sync_period_sel',
'sync_gen_sync_period_var',
'sys_board_id',
'sys_clkcounter',
'sys_rev',
'sys_rev_rcs',
'sys_scratchpad',
'write_done']
thanks,
Franco
On 02/12/16 10:02, Marc Welz wrote:
Then there is no bitstream programmed or the particular bitstream
doesn't contain that register. Type
?listdev
on that connection to find out
regards
marc
On Fri, Dec 2, 2016 at 12:52 PM, Franco <francocuro...@gmail.com> wrote:
It says: #log error 1018802834854 raw
register\_dram_controller\_not\_defined
Franco
On 02/12/16 04:32, Marc Welz wrote:
telnet to the roach on port 7147 while repeating the operation - what
do the #log messages say ?
On Thu, Dec 1, 2016 at 3:43 PM, Franco <francocuro...@gmail.com> wrote:
Hi!
I tried to test the dram of ROACH2 by porting an example model I had for
ROACH1.
However when I tried to read the dram I got the following error:
RuntimeError: Request write failed.
Request: ?write dram_controller 0 \0\0\0\0
Reply: !write fail.
Someone knows what's the problem?
thanks,
Franco Curotto