On Thu, 13 Mar 2008, Max Hodgson wrote:
I use Dell 124T tape loaders with Centos. The controlling device on mine is
separate to the data device.
Turned out to be at least the need for a new scsi card, which I obtained.
I also used a new machine. But your experience below did lead me to
review dmesg more carefully, which led to the proper device that happened
to not be /dev/st0. mtx did respond positively. It is possible the first
"problem" machine could work with the new card, but I have other things to
battle :-)
Thanks again.
Scott
e.g.
I use:
$> mtx -f /dev/sg1 status
But for writing to tape:
$> tar cvf /dev/st0 /etc
I think the dmesg told me which device to use to control.
mjh
On 13/03/2008, Scott R. Ehrlich <[EMAIL PROTECTED]> wrote:
My unit's firmware: library 05.03, tape d22h, shows the device as set to
random mode. But mtx -f /dev/st0 status gives an error that google says
the device is in sequential mode. dmesg|grep -i hp does reflect CentOS
thinks the device is a sequential unit.
I've tried this with Fedora 8, too, and both show the same, so it is
either an issue with CentOS/Fedora RPMs, or the version of MTX?
I'm going to try a simple install of Ubuntu next and see if there is any
difference.
Is this a bug with the firmware, or with my setup?
I have rebooted the tape drive and machine several times.
I have the drive connected to an Adaptec 29160.
I have another identical drive on another system, with a library firmware
of d21h, tape firmware 04.04, and that works perfectly with mtx, though it
is connected to a different SCSI card.
Thanks for any help/insights.
Scott
_______________________________________________
CentOS mailing list
CentOS@centos.org
http://lists.centos.org/mailman/listinfo/centos
_______________________________________________
CentOS mailing list
CentOS@centos.org
http://lists.centos.org/mailman/listinfo/centos
