I think you should be looking into this first "WPA: No SSID info found (msg 1 of 4)"
If WPA cant see the SSID, then nothing that follows will work. Is the AP transmitiing its SSID - if not turn it on for testing at least (cant confirm, but I suspect it must be on for wifi to work). What does "iwlist eth0 scan" show? - remember the FR wifi setup is DEAF - you need to be twice as close to the AP as a typical laptop with a solid connection to even see the AP - and ideally a couple of meters away when testing like this to remove doubt. Install wmiconfig and run "wmiconfig -i eth0 --power maxperf" after powering on the wifi chip and before scanning. WPA[1|2] works fine for me using wifi manually in a similar fashion to you - but I am currently on shr. There are also wifi issues with some kernels, but I have not used qtmoko so cant say if thats one of them. BillK On Sun, 2009-09-13 at 13:13 +0200, Torfinn Ingolfsen wrote: > Hi, > > On Sun, Sep 13, 2009 at 8:24 AM, Ronald Tallent <r...@tallent.ws> > wrote: > Short answer, yes. > > If you haven't already you should probably check out: > http://wiki.openmoko.org/wiki/Special:Search?search=manually > +using > +wifi&go=Go > > Ok, I jave now read that - thanks. > I'm doing > ifconfig eth0 up > wpa_supplicant -c /etc/wpa_supplicant/wpa_supplicant.conf -i eth0 > > wpa-supplicant spews this: > r...@neo:~# wpa_supplicant -c /etc/wpa_supplicant/wpa_supplicant.conf > -i eth0 > ioctl[SIOCSIWENCODEEXT]: Operation not supported > ioctl[SIOCSIWENCODEEXT]: Operation not supported > ioctl[SIOCSIWENCODEEXT]: Operation not supported > ioctl[SIOCSIWENCODEEXT]: Operation not supported > CTRL-EVENT-SCAN-RESULTS > WPA: No SSID info found (msg 1 of 4). > CTRL-EVENT-SCAN-RESULTS > Trying to associate with 00:0f:66:51:aa:41 (SSID='kg4' freq=2417 MHz) > Associated with 00:0f:66:51:aa:41 > Authentication with 00:0f:66:51:aa:41 timed out. > ioctl[SIOCSIWMLME]: Operation not supported > Associated with 00:0f:66:51:aa:41 > Associated with 00:0f:66:51:aa:41 > CTRL-EVENT-SCAN-RESULTS > Trying to associate with 00:0f:66:51:aa:41 (SSID='kg4' freq=2417 MHz) > Associated with 00:0f:66:51:aa:41 > > and goes on and on > > And in another shell: > > udhcpc eth0 > udhcpc says: > r...@neo:/home/root# udhcpc eth0 > udhcpc (v0.9.9-pre) started > Sending discover... > Sending discover... > Sending discover... > Lease failed: > Sending discover... > Sending discover... > Sending discover... > Lease failed: > > Does anyone have wireless working with WPA encryption on their > FreeRunner? > -- > Regards, > Torfinn Ingolfsen > _______________________________________________ > Openmoko community mailing list > community@lists.openmoko.org > http://lists.openmoko.org/mailman/listinfo/community -- William Kenworthy <bi...@iinet.net.au> Home in Perth! _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community