The binding definition is based on the generic DMA request binding.
Signed-off-by: Matt Porter <mpor...@ti.com>
---
.../devicetree/bindings/mmc/ti-omap-hsmmc.txt | 25 +++++++++++++++++++-
1 file changed, 24 insertions(+), 1 deletion(-)
diff --git a/Documentation/devicetree/bindings/mmc/ti-omap-hsmmc.txt
b/Documentation/devicetree/bindings/mmc/ti-omap-hsmmc.txt
index ed271fc..826cc51 100644
--- a/Documentation/devicetree/bindings/mmc/ti-omap-hsmmc.txt
+++ b/Documentation/devicetree/bindings/mmc/ti-omap-hsmmc.txt
@@ -20,8 +20,28 @@ ti,dual-volt: boolean, supports dual voltage cards
ti,non-removable: non-removable slot (like eMMC)
ti,needs-special-reset: Requires a special softreset sequence
ti,needs-special-hs-handling: HSMMC IP needs special setting for handling High
Speed
+dmas: DMA controller phandle and DMA request value ordered pair
+One tx and one rx pair is required.
+dma-names: DMA request names. These strings correspond 1:1 with
+the ordered pairs in dmas. The RX request must be "rx" and the
+TX request must be "tx".
+
+Examples:
+
+[hwmod populated DMA resources]
+
+ mmc1: mmc@0x4809c000 {
+ compatible = "ti,omap4-hsmmc";
+ reg = <0x4809c000 0x400>;
+ ti,hwmods = "mmc1";
+ ti,dual-volt;
+ bus-width = <4>;
+ vmmc-supply = <&vmmc>; /* phandle to regulator node */
+ ti,non-removable;
+ };
+
+[generic DMA request binding]
-Example:
mmc1: mmc@0x4809c000 {
compatible = "ti,omap4-hsmmc";
reg = <0x4809c000 0x400>;
@@ -30,4 +50,7 @@ Example:
bus-width = <4>;
vmmc-supply = <&vmmc>; /* phandle to regulator node */
ti,non-removable;
+ dmas = <&edma 24
+ &edma 25>;
+ dma-names = "tx", "rx";
};
--
1.7.9.5
_______________________________________________
Davinci-linux-open-source mailing list
Davinci-linux-open-source@linux.davincidsp.com
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
