Да, с температурой плохо, но 46 - это нормально.
85 - обычное значение для Trip Temperature, это предел, диск выключится,
если будет столько.
> Тоже хорошо лист раздулся ^^^^^^^^^^^
Только на этом диске.
> С соседнего диска покажи вывод, для сравнения.
Там всё ok.
Приложил для sdb.
29.10.2020 13:06, Andrey Jr. Melnikov пишет:
artiom <artio...@yandex.ru> wrote:
[-- text/plain, encoding 8bit, charset: utf-8, 41 lines --]
Здравствуйте.
Диск вываливается из пула второй раз.
Это говорит о том, что диск пора менять?
Угу.
Полный отчёт приложил.
[...]
=== START OF READ SMART DATA SECTION ===
SMART Health Status: OK
Current Drive Temperature: 46 C
Жарко им там. Сильно жарко.
Drive Trip Temperature: 85 C
Manufactured in week 06 of year 2016
Specified cycle count over device lifetime: 50000
Accumulated start-stop cycles: 113
Specified load-unload count over device lifetime: 600000
Accumulated load-unload cycles: 1029
Elements in grown defect list: 2063
Тоже хорошо лист раздулся ^^^^^^^^^^^
Vendor (Seagate) cache information
Blocks sent to initiator = 16398532122509312
Error counter log:
Errors Corrected by Total Correction Gigabytes
Total
ECC rereads/ errors algorithm processed
uncorrected
fast | delayed rewrites corrected invocations [10^9 bytes]
errors
read: 275976895 188907 0 276165802 12936691 40078.468
21
write: 0 237 0 237 1360289 44744.849
0
verify: 0 0 0 0 41935114 0.000
0
Non-medium error count: 7
С соседнего диска покажи вывод, для сравнения.
smartctl 6.6 2017-11-05 r4594 [x86_64-linux-5.7.0-0.bpo.2-amd64] (local build)
Copyright (C) 2002-17, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Vendor: HGST
Product: HUS724040ALS640
Revision: A320
Compliance: SPC-4
User Capacity: 4,000,787,030,016 bytes [4.00 TB]
Logical block size: 512 bytes
LU is fully provisioned
Rotation Rate: 7200 rpm
Form Factor: 3.5 inches
Logical Unit id: 0x5000cca07369c40c
Serial number: PEHW55YX
Device type: disk
Transport protocol: SAS (SPL-3)
Local Time is: Thu Oct 29 23:22:33 2020 MSK
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
Temperature Warning: Enabled
Read Cache is: Enabled
Writeback Cache is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART Health Status: OK
Current Drive Temperature: 45 C
Drive Trip Temperature: 85 C
Manufactured in week 06 of year 2016
Specified cycle count over device lifetime: 50000
Accumulated start-stop cycles: 113
Specified load-unload count over device lifetime: 600000
Accumulated load-unload cycles: 1030
Elements in grown defect list: 0
Vendor (Seagate) cache information
Blocks sent to initiator = 30411439726395392
Error counter log:
Errors Corrected by Total Correction Gigabytes
Total
ECC rereads/ errors algorithm processed
uncorrected
fast | delayed rewrites corrected invocations [10^9 bytes]
errors
read: 375435 1 0 375436 1195859 52736.418
0
write: 0 0 0 0 1909068 56323.792
0
verify: 0 0 0 0 10458 0.000
0
Non-medium error count: 0
SMART Self-test log
Num Test Status segment LifeTime LBA_first_err
[SK ASC ASQ]
Description number (hours)
# 1 Background short Completed - 1813 -
[- - -]
# 2 Background long Completed - 230 -
[- - -]
# 3 Background short Completed - 221 -
[- - -]
# 4 Background short Completed - 201 -
[- - -]
# 5 Background short Completed - 157 -
[- - -]
# 6 Background short Completed - 133 -
[- - -]
# 7 Background short Completed - 2 -
[- - -]
# 8 Background short Completed - 2 -
[- - -]
# 9 Background short Completed - 1 -
[- - -]
Long (extended) Self Test duration: 37452 seconds [624.2 minutes]
Background scan results log
Status: waiting until BMS interval timer expires
Accumulated power on time, hours:minutes 22113:38 [1326818 minutes]
Number of background scans performed: 145, scan progress: 0.00%
Number of background medium scans performed: 145
Protocol Specific port log page for SAS SSP
relative target port id = 1
generation code = 2
number of phys = 1
phy identifier = 0
attached device type: no device attached
attached reason: unknown
reason: power on
negotiated logical link rate: phy enabled; unknown
attached initiator port: ssp=0 stp=0 smp=0
attached target port: ssp=0 stp=0 smp=0
SAS address = 0x5000cca07369c40d
attached SAS address = 0x0
attached phy identifier = 0
Invalid DWORD count = 0
Running disparity error count = 0
Loss of DWORD synchronization = 0
Phy reset problem = 0
Phy event descriptors:
Invalid word count: 0
Running disparity error count: 0
Loss of dword synchronization count: 0
Phy reset problem count: 0
relative target port id = 2
generation code = 2
number of phys = 1
phy identifier = 1
attached device type: SAS or SATA device
attached reason: unknown
reason: unknown
negotiated logical link rate: phy enabled; 6 Gbps
attached initiator port: ssp=1 stp=1 smp=1
attached target port: ssp=0 stp=0 smp=0
SAS address = 0x5000cca07369c40e
attached SAS address = 0x5d05099000005171
attached phy identifier = 4
Invalid DWORD count = 0
Running disparity error count = 0
Loss of DWORD synchronization = 0
Phy reset problem = 0
Phy event descriptors:
Invalid word count: 0
Running disparity error count: 0
Loss of dword synchronization count: 0
Phy reset problem count: 0