On Thu, Aug 30, 2012 at 11:50:09PM -0400, Kamaraju S Kusumanchi wrote: > developing bad blocks. They are usually at room temperature (no air > conditioning), partitioned via cfdisk + mke2fs.
I think room temperature is a vague term considering the temperature range which occurs in each country. The specifications of a device normally give the operating range. Personally, I believe that it is sudden changes in temperature which is more problematic. So if someone says room temperature to me: I'm assuming 18 degrees C to around 25 degrees C. Of course, this is not always the actual temperature. For example, in the Summer It can reach lower 30's (unusual in this neck of the woods, but occassionally happens) whereas in the Winter it only drops to around -5 at the extreme, although this is only occassionally as well. My guess is that in "hot countries", where, during the day the temperatures can be reasonably unbearable, and then at night where the temperatures can be a "bit chilly" will be more problematic than in countries where the temperatures don't vary as much. So even if the operating temperature is well within the specifications, the amount of variation may be a factor. The term controlled environment says to me, that it is controlled as far as the equipment is concerned, not humans. I am not too sure what the ideal temperature for a hard drive to operate at but I remember that in an unmanned electronic telephone exchange it was rather uncomfortable for humans, and there was a switch on the wall which you could press which would alter the humidity (and temperature?) so as to be a bit more healthy for humans. I think a better term would be "office environment" for where it is controlled for human comfort. Also I forgot to mention that humidity could be a major factor on hard drive reliability and MTBF. -- "If you're not careful, the newspapers will have you hating the people who are being oppressed, and loving the people who are doing the oppressing." --- Malcolm X -- To UNSUBSCRIBE, email to debian-user-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org Archive: http://lists.debian.org/20120903061819.GC25171@tal