Hi Albrecht! Am Samstag, 29. September 2012 schrieb Albretch Mueller: […] > [11750.572197] ata2: SATA link down (SStatus 0 SControl 300) > [11750.572245] ata1: SATA link down (SStatus 0 SControl 300) > [11750.676244] ata3.00: ACPI cmd ef/03:0c:00:00:00:a0 (SET FEATURES) > filtered out > [11750.676248] ata3.00: ACPI cmd ef/03:42:00:00:00:a0 (SET FEATURES) > filtered out > [11750.676252] ata3.00: ACPI cmd f5/00:00:00:00:00:a0 (SECURITY FREEZE > LOCK) filtered out > [11750.682804] ata3.00: configured for UDMA/33 > [11755.300321] psmouse serio1: hgpk: ID: 10 00 64 > [11757.745503] > [11757.745504] floppy driver state > [11757.745505] ------------------- > [11757.745513] now=3437324 last interrupt=1109734 diff=2327590 last > called handler=recal_interrupt > [11757.745515] timeout_message=lock fdc > [11757.745517] last output bytes: > [11757.745518] 18 80 4294884748 > [11757.745520] 8 80 4294884748 > [11757.745522] 8 80 4294884748 > [11757.745523] 8 80 4294884748 > [11757.745525] 8 80 4294884748 > [11757.745527] 12 80 1109103 > [11757.745528] 0 90 1109103 > [11757.745530] 13 90 1109103 > [11757.745531] 0 90 1109103 > [11757.745533] 1a 90 1109103 > [11757.745534] 0 90 1109103 > [11757.745536] 3 80 1109103 > [11757.745537] c1 90 1109103 > [11757.745539] 10 90 1109103 > [11757.745540] 7 80 1109103 > [11757.745542] 0 90 1109103 > [11757.745544] 8 81 1109416 > [11757.745545] 7 80 1109422 > [11757.745547] 0 90 1109422 > [11757.745548] 8 81 1109734 > [11757.745550] last result at 1109734 > [11757.745551] last redo_fd_request at 1121152 > [11757.745554] 70 00 p. > [11757.745564] status=0 > [11757.745566] fdc_busy=1 > [11757.745569] do_floppy=reset_interrupt > [11757.745571] cont=f85786c8 > [11757.745572] current_req= (null) > [11757.745574] command_status=-1 > [11757.745575] > [11757.745578] floppy0: floppy timeout called > [11757.745604] PM: resume of devices complete after 7495.396 msecs > [11757.745866] Restarting tasks ... done. > [11758.374389] VFS: busy inodes on changed media or resized disk sr0 > [11758.376145] ADDRCONF(NETDEV_UP): eth0: link is not ready > [11760.048064] tg3 0000:02:00.0: eth0: Link is up at 100 Mbps, full duplex > [11760.048068] tg3 0000:02:00.0: eth0: Flow control is on for TX and on for RX > [11760.048247] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready > [11770.228921] eth0: no IPv6 routers present > [11952.768836] usb 1-8: new high-speed USB device number 4 using ehci_hcd > [11952.898331] usb 1-8: New USB device found, idVendor=0930, idProduct=6545 > [11952.898334] usb 1-8: New USB device strings: Mfr=1, Product=2, > SerialNumber=3 > [11952.898337] usb 1-8: Product: DT 101 G2 > [11952.898340] usb 1-8: Manufacturer: Kingston > [11952.898342] usb 1-8: SerialNumber: 001CC0C83B35EB61142A011A > [11952.899440] scsi6 : usb-storage 1-8:1.0 > [11953.948116] scsi 6:0:0:0: Direct-Access Kingston DT 101 G2 > PMAP PQ: 0 ANSI: 0 CCS > [11953.948296] sd 6:0:0:0: Attached scsi generic sg1 type 0 > [11954.607947] sd 6:0:0:0: [sda] 15638528 512-byte logical blocks: > (8.00 GB/7.45 GiB) > [11954.610064] sd 6:0:0:0: [sda] Write Protect is off > [11954.610068] sd 6:0:0:0: [sda] Mode Sense: 23 00 00 00 > [11954.612344] sd 6:0:0:0: [sda] No Caching mode page present > [11954.612347] sd 6:0:0:0: [sda] Assuming drive cache: write through > [11954.619566] sd 6:0:0:0: [sda] No Caching mode page present > [11954.619569] sd 6:0:0:0: [sda] Assuming drive cache: write through > [11954.641593] sda: sda1 > [11954.647337] sd 6:0:0:0: [sda] No Caching mode page present > [11954.647342] sd 6:0:0:0: [sda] Assuming drive cache: write through > [11954.647345] sd 6:0:0:0: [sda] Attached SCSI removable disk > [12011.869055] end_request: I/O error, dev fd0, sector 0 > [12097.222509] end_request: I/O error, dev fd0, sector 0 > [12150.892906] end_request: I/O error, dev fd0, sector 0 > [12209.992320] end_request: I/O error, dev fd0, sector 0 > [22999.715096] usb 1-8: USB disconnect, device number 4 > [22999.974401] usb 1-8: new high-speed USB device number 5 using ehci_hcd > [23000.494403] usb 1-8: device not accepting address 5, error -71 > [23000.547764] hub 1-0:1.0: unable to enumerate USB device on port 8 > [23431.424360] usb 1-8: new high-speed USB device number 7 using ehci_hcd > [23431.553861] usb 1-8: New USB device found, idVendor=0930, idProduct=6545 > [23431.553866] usb 1-8: New USB device strings: Mfr=1, Product=2, > SerialNumber=3 > [23431.553869] usb 1-8: Product: DT 101 G2 > [23431.553871] usb 1-8: Manufacturer: Kingston > [23431.553874] usb 1-8: SerialNumber: 001CC0C83B35EB61142A011A > [23431.555077] scsi7 : usb-storage 1-8:1.0 > [23432.603528] scsi 7:0:0:0: Direct-Access Kingston DT 101 G2 > PMAP PQ: 0 ANSI: 0 CCS > [23432.603703] sd 7:0:0:0: Attached scsi generic sg1 type 0 > [23433.241968] sd 7:0:0:0: [sda] 15638528 512-byte logical blocks: > (8.00 GB/7.45 GiB) > [23433.244088] sd 7:0:0:0: [sda] Write Protect is off > [23433.244091] sd 7:0:0:0: [sda] Mode Sense: 23 00 00 00 > [23433.246215] sd 7:0:0:0: [sda] No Caching mode page present > [23433.246218] sd 7:0:0:0: [sda] Assuming drive cache: write through > [23433.253714] sd 7:0:0:0: [sda] No Caching mode page present > [23433.253718] sd 7:0:0:0: [sda] Assuming drive cache: write through > [23433.275741] sda: sda1 > [23433.281860] sd 7:0:0:0: [sda] No Caching mode page present > [23433.281865] sd 7:0:0:0: [sda] Assuming drive cache: write through > [23433.281869] sd 7:0:0:0: [sda] Attached SCSI removable disk > [25983.383683] usb 1-8: USB disconnect, device number 7 > [26199.587825] end_request: I/O error, dev fd0, sector 0
Two ideas: 1) floppy device activated in BIOS while no floppy device present 2) floppy emulation for USB mass storage activated in BIOS Ciao, -- Martin 'Helios' Steigerwald - http://www.Lichtvoll.de GPG: 03B0 0D6C 0040 0710 4AFA B82F 991B EAAC A599 84C7 -- To UNSUBSCRIBE, email to debian-user-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org Archive: http://lists.debian.org/201209291229.10912.mar...@lichtvoll.de
