Hi Mathias,
with copying the missing config files the build works so far, that I can
use it to debug in sc.
Mathias Bauer schrieb:
On 16.05.2011 12:15, Regina Henschel wrote:
Hi Mathias,
Mathias Bauer schrieb:
On 16.05.2011 11:10, Regina Henschel wrote:
I have got the source from http://hg.services.openoffice.org/DEV300/
I have applied the patch from
http://openoffice.org/bugzilla/show_bug.cgi?id=117793
I have set --enable-cairo in my config settings.
I have build and delivered cairo manually.
Does that mean that you don't have these problems if you build without
--enable-cairo?
Without --enable-cairo setting or with setting --disable-cairo it
doesn't build at all, because pango is missing cairo.h. If I then try to
build cairo manually, it says that it is not enabled.
I can not confirm this problem. I had no problem with building OOo
DEV300_m106 on Windows/cygwin without specifying any cairo related
switches.
I do a build with switch --enable-dbgutil, does it make a difference?
There had been at lot of stops and resuming, that I think it is best, if
I start from scratch again, and then report each single problem
immediately. Perhaps then it is easier to see, what goes wrong in my
environment. Shall I start without any cairo related switches?
Kind regards
Regina
--
-----------------------------------------------------------------
To unsubscribe send email to dev-unsubscr...@openoffice.org
For additional commands send email to sy...@openoffice.org
with Subject: help