BTW, after removing the power resistor, you must be careful to clean off excess solder, because the crucial gap is small and "embedded" in the large pads. I had to use ChipQuick to get the resistor off, then I had to add regular solder back to the pad to alloy with the ChipQuik, as ChipQuik doesn't flow onto solder wick very well.
Richard A. Smith wrote: >> With the dongle connected to the serial connector on the B3, it comes up >> with serial enabled. Disconnected, serial is disabled. >> >> I haven't tried the pencil-enable technique. >> > > The new batch of serial adapters with this enable signal built in should be > ready in about a week or so. 1cc will have a small stash of them and the > rest will be available from the association and spare parts places like XO > Explosion, etc. > > _______________________________________________ Devel mailing list Devel@lists.laptop.org http://lists.laptop.org/listinfo/devel
