Hi, 855resolustion does not work for me ;-(. I am running Fedora Core 2, with Xorg version (X -version): Release Date: 18 December 2003 X Protocol Version 11, Revision 0, Release 6.7 I suppose this is the same as XFree86 4.4 RC2. lspci -vv says (for the graphics card): 00:02.0 VGA compatible controller: Intel Corp. 82852/855GM Integrated Graphics Device (rev 02) (prog-if 00 [VGA]) Subsystem: COMPAL Electronics Inc: Unknown device 0012 Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 0 Interrupt: pin A routed to IRQ 11 Region 0: Memory at e8000000 (32-bit, prefetchable) Region 1: Memory at e0000000 (32-bit, non-prefetchable) [size=512K] Region 2: I/O ports at 1800 [size=8] Capabilities: [d0] Power Management version 1 Flags: PMEClk- DSI+ D1+ D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=0 PME- 00:02.1 Display controller: Intel Corp. 82852/855GM Integrated Graphics Device (rev 02) Subsystem: COMPAL Electronics Inc: Unknown device 0012 Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- Region 0: Memory at f0000000 (32-bit, prefetchable) [disabled] Region 1: Memory at e0080000 (32-bit, non-prefetchable) [disabled] [size=512K] Capabilities: [d0] Power Management version 1 Flags: PMEClk- DSI+ D1+ D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=0 PME- When I run the "855resolution -l" (v0.2), I get: Chipset: 855GM VBIOS type: 1 VBIOS Version: 2880 (the same modes list of Xorg.0.log) Using v0.1, "855resolution -l" gives: Chipset: 855GM BIOS Configuration area offset: 0x0c20 bytes BIOS Version: 80Mo (strange modes list) Since 1024x768 does not work on my laptop, I try to replace mode 800x600x16bits (mode 43, as reported both by 855resoluviov0.2 and Xorg.0.log) by mode 1024x768 (16bits?): init 3 855resolution 43 1024 768 init 5 855resolution says the mode has been replaced, but Xorg does not find neither the new 1024x768 nor the replaced 800x600, and starts in 640x480 ;-(. I tryed inserting a modline for 1024x768, but that did not work. I tryed removing all references to any mode other than 1024x768 in xorg.conf, but that did not work either. Suggestions are welcome. Thanks a lot, Sérgio BTW: WindowsXP runs with 1024x768 in the same machine. S Streif wrote: Hellodeimos# ./855resolution -l Chipset: 855GM Unknow VBIOS structure deimos#I have a Acer TM 661 and someone already posted that it worked on his machine.I'm using an ACER TM661 as well and I got the same message ("Unknown VBIOS structure"). After changing line 34 to *bios_type = 0; the patch works with my laptop. I hope this helps. Regards, Stefan Streif _______________________________________________ Devel mailing list [EMAIL PROTECTED] http://XFree86.Org/mailman/listinfo/devel |
- Re: SOLVED: 1400x1050 on a Dell 510m oliver.bantke
- Re: SOLVED: 1400x1050 on a Dell 510m S Streif
- Re: SOLVED: 1400x1050 on a Dell 510m Nqnsome
- Re: SOLVED: 1400x1050 on a Dell 510m Christian Zietz