If you don't need packagesupport try the embedded version. It has the output at com1 at 9600 baud. Assign Interfaces there and do the rest in the webgui.
Holger > -----Ursprüngliche Nachricht----- > Von: Scott Ullrich [mailto:[EMAIL PROTECTED] > Gesendet: Donnerstag, 5. Januar 2006 22:40 > An: discussion@pfsense.com > Betreff: Re: [pfSense-discussion] Headless boot > > > This is somehwat not true. PFI allows one to setup a pre > installation environment, ssh enabled, root password change, etc. > > On 1/5/06, Craig FALCONER <[EMAIL PROTECTED]> wrote: > > No. You need a monitor to begin with, but once config is > done you should > > never need it again. > > > > > > -----Original Message----- > > From: news [mailto:[EMAIL PROTECTED] On Behalf Of ihavenoname > > Sent: Friday, 30 December 2005 9:53 a.m. > > To: discussion@pfsense.com > > Subject: [pfSense-discussion] Headless boot > > > > > > I have an old Pentium II without a monitor. Is it possible > for pfSense to > > automatically detect networks cards and get itself into a > state where I can > > do the manual configuration remotely (ssh, web, ... etc)? > > > > Thanks > > > > > ____________ Virus checked by G DATA AntiVirusKit
