This adds a new binding for Sitronix ST7586 display panels.
Using lego as the vendor prefix in the compatible string because the display
panel I am working with is an integral part of the LEGO MINDSTORMS EV3.
Signed-off-by: David Lechner <da...@lechnology.com>
---
v4 changes:
* Dropped optional properties and only use pins actually used on LEGO EV3.
* Rename dc to a0 since that is what is on the datasheet/LEGO schematic.
.../bindings/display/sitronix,st7586.txt | 22 ++++++++++++++++++++++
1 file changed, 22 insertions(+)
create mode 100644
Documentation/devicetree/bindings/display/sitronix,st7586.txt
diff --git a/Documentation/devicetree/bindings/display/sitronix,st7586.txt
b/Documentation/devicetree/bindings/display/sitronix,st7586.txt
new file mode 100644
index 0000000..1d0dad1
--- /dev/null
+++ b/Documentation/devicetree/bindings/display/sitronix,st7586.txt
@@ -0,0 +1,22 @@
+Sitronix ST7586 display panel
+
+Required properties:
+- compatible: "lego,ev3-lcd".
+- a0-gpios: The A0 signal (since this binding is for serial mode, this is
+ the pin labeled D1 on the controller, not the pin labeled A0)
+- reset-gpios: Reset pin
+
+The node for this driver must be a child node of a SPI controller, hence
+all mandatory properties described in ../spi/spi-bus.txt must be specified.
+
+Optional properties:
+- rotation: panel rotation in degrees counter clockwise (0,90,180,270)
+
+Example:
+ display@0{
+ compatible = "lego,ev3-lcd";
+ reg = <0>;
+ spi-max-frequency = <10000000>;
+ a0-gpios = <&gpio 43 GPIO_ACTIVE_HIGH>;
+ reset-gpios = <&gpio 80 GPIO_ACTIVE_HIGH>;
+ };
--
2.7.4
_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/dri-devel
