It would be better to put "usbduxsigma:" in the patch title instead of
"drivers:" since it's only for a single driver.
On 2013-12-28 21:32, Bernd Porr wrote:
Removed the word "attached" from the "ADC_zero" output which is
now reported by comedi itself at the end of the auto attach.
A negative value of the offset is an error and should be reported to
comedi auto config as an error. Output only the offset if no error
has been reported.
Signed-off-by: Bernd Porr <m...@berndporr.me.uk>
---
drivers/staging/comedi/drivers/usbduxsigma.c | 9 ++++++---
1 file changed, 6 insertions(+), 3 deletions(-)
diff --git a/drivers/staging/comedi/drivers/usbduxsigma.c
b/drivers/staging/comedi/drivers/usbduxsigma.c
index a5363de..125eae5 100644
--- a/drivers/staging/comedi/drivers/usbduxsigma.c
+++ b/drivers/staging/comedi/drivers/usbduxsigma.c
@@ -1656,11 +1656,14 @@ static int usbduxsigma_auto_attach(struct comedi_device
*dev,
}
offset = usbduxsigma_getstatusinfo(dev, 0);
- if (offset < 0)
+ if (offset < 0) {
+ /* a neg ADC value in comedi terms is a device error */
dev_err(dev->class_dev,
- "Communication to USBDUXSIGMA failed! Check firmware and
cabling\n");
+ "Communication to USBDUXSIGMA failed! Check firmware and
cabling.\n");
+ return offset;
+ }
- dev_info(dev->class_dev, "attached, ADC_zero = %x\n", offset);
+ dev_info(dev->class_dev, "ADC_zero = %x\n", offset);
return 0;
}
Ideally, it would be two patches, one to return the error and the other
to correct the messages, but doesn't matter too much.
Reviewed-by: Ian Abbott <abbo...@mev.co.uk>
--
-=( Ian Abbott @ MEV Ltd. E-mail: <abbo...@mev.co.uk> )=-
-=( Tel: +44 (0)161 477 1898 FAX: +44 (0)161 718 3587 )=-
_______________________________________________
devel mailing list
de...@linuxdriverproject.org
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
