Jim, Thanks for the guidance. The IC-9700 rig file DID NOT WORK with the IC-9100.
The IC-7100 "No auto-on" rig file DOES WORK with the IC-9100 when changing the radio address to 7C and the baud to 19200 (remove the 2 "Default check marks"). My radio Baud was set to 19200 and also tried AUTO on the IC-9100 CI-V Baud Rate settings (60). Both worked. The com port was the IC-9100 first port (A) that was created by the ICOM downloaded Silicon Labs Com Port driver. In my case the Com Port driver created Silicon Labs CP210x USB to UART Bridge Com 10 and Com 11. Port 10 worked, port 11 did not work. Regards - Terry KS5Z -----Original Message----- From: Jim Reisert AD1C [mailto:jjreis...@alum.mit.edu] Sent: Saturday, December 19, 2020 10:57 AM To: Terry Cc: DX4WIN Reflector Subject: Re: [Dx4win] IC-9100 Rig File On Fri, Dec 18, 2020 at 11:43 AM Terry - KS5Z wrote: > Looking for an ICOM IC-9100 rig file or substitute. > Any help would be appreciated. Terry, try the IC-9700 driver: http://dx4win.ad1c.us/radios/index.html#ICOM You will have to change the address code from "A2" to "7C". And make sure you get the baud rate right. Please report back to the reflector if it works for you. The IC-7100 driver may also work, and may be a better starting point. -- Jim Reisert AD1C, <jjreis...@alum.mit.edu>, https://www.ad1c.us ______________________________________________________________ DX4WIN mailing list Home: http://mailman.qth.net/mailman/listinfo/dx4win Help: http://mailman.qth.net/mmfaq.htm Post: mailto:DX4WIN@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
