Hi All: I'm just finishing up my KPA100. I see that the #5-40 TapTite screws used for fastening the K2 side panel to the slotted edge of the heat sink are not included in the kit.
I've yet to even use the standard screws in the slot. I'm wondering if it's better if I just order the TapTites now rather then end up stripping the hole out later? Does the use of the TapTite screws work as a preventative measure? It seems just providing a threaded hole from the get-go would have been a better solution. Frank, W4FMS _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net http://mailman.qth.net/mailman/listinfo/elecraft You must subscribe to post. Subscriber Info (Addr. Change, Unsub etc): http://mailman.qth.net/subscribers.htm Elecraft page: http://www.elecraft.com