On Aug 10, 2004, at 6:04 PM, Tom Mc wrote:
I've also built the XG1 signal generator and would like to trace the
signal through my K2.
Hi Tom,
The signal put out by the XG1 is so low in amplitude that the only
point in the circuit you can trace with it is the audio amplifier, and
perhaps the output of the product detector. It is intended for
calibration at signal levels usually only seen in on-air operation (1
to 50 microvolts).
If you'd like to trace signals through the rest of the receive chain,
you'll need a signal in the 10s or 100s of millivolts. That's where the
oscillator in Appendix E comes in. We provided a full list of
signal-tracing points based on the use of this oscillator and the RF
probe supplied with the K2.
73,
Wayne
N6KR
---
http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com