Glad you found it Ian.
That again substantiates the advuse to builders who encounter a problem -
check soldering, and then re-check soldering. Then when you have finished,
check the soldering!!! Remember, the circuits do work as designed and
component failure is rare.
73,
Don W3FPR
----- Original Message -----
Hi all,
I finally fixed the problems I was having on the 160m alignment. I
could not get 10W no matter how I tried. Thanks go to Don, W3FPR and
Bob, G3VVT for their ideas. In the end, I did not seem to be getting
any joy when tuning L3 and L4. L4 I could peak but nothing seemed to be
happening with L3 so I took the heatsink off (yet again!).
Would you believe the fault had been there since I built the rig and I
had never noticed up to this point. On terminal of L3 was not
soldered. It must have been making a little on the through plating.
Once soldered I now could tune properly on 160m :-)
Lots of learning learnt!
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com