On Feb 14, 2005, at 12:33 PM, <[EMAIL PROTECTED]> wrote:
I verified that I can in fact hear the two identical and separate
tones by adjusting the trimmer C27 in the KPA 100. I am just not sure
what the intent of the adjustment is other than to verify the two
sources for the audio tone on 80 meters. What am I doing when I
adjust C27 to move to tone above the 4 MHz region?
73 KI4DGH
Chuck G.
Hi Chuck,
The adjustment is provided just to ensure that the KPA100's oscillator
doesn't fall below 4000 kHz. If it did, it could conceivably interfere
with on-air signals. You can use C27 to position it slightly above 4000
kHz if necessary.
The K2 itself also has a 4000 kHz oscillator, which gets adjusted to
exactly 4000 kHz as part of the alignment. This will not interfere with
LSB signals at or below the band edge.
73,
Wayne
N6KR
---
http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com