The KPA500 requires 30 to 40 watts for full output. With 10 watts of drive the output will be around 200 watts or a little less.
Bob, N6CM On Wed, Sep 8, 2010 at 8:15 PM, Phil Townsend <phi...@mac.com> wrote: > The KPA 500? > Will I need to upgrade to the 100 watt machine or will the ten watt k3 do > the job. > > Phil > Santa Fe, NM > > Sent from my iPad > > On Sep 8, 2010, at 6:58 PM, Lyle Johnson <k...@wavecable.com> wrote: > > > Yes, except the fan on the rear is a bit deeper than the twin fans on > > the K3/100. > > > > 73, > > > > Lyle KK7P > > > > Is the form factor for the yet to be available KPA500 the same as my K3? > > > > ______________________________________________________________ > > Elecraft mailing list > > Home: http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/mmfaq.htm > > Post: mailto:Elecraft@mailman.qth.net > > > > This list hosted by: http://www.qsl.net > > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html