This is the Elecraft user's email list - we are users and not Elecraft staff. To order parts, you can either order from the website www.Elecraft.com or send an email to either sa...@elecraft.com or pa...@elecraft.com.
If I understand your board swapping correctly, you have proven that the Control Board (but not the MCU - U6) is producing the problem. I suggest doing the Control Board DC Voltage measurements in appendix E of the manual. Do mind the setup notes at the top of the DC Voltage Table. Please clarify - in the beginning, you said "no frequency display", but later, you mentioned a display of "0.000.00 or 15.999.99". Please tell us if the display is blank or just incorrect - 0.000.00 is a display of zero frequency, That IS a display of something even though incorrect ("no frequency display" is blank). If an incorrect frequency display is your problem, try a Direct Frequency Entry for each amateur band (use a mid-band frequency). 73, Don W3FPR On 1/7/2012 10:03 AM, Robert DROGOUL wrote: > Hi Waine, and all the team > > First thing first, a Happy New Year 2012 to all the team! > > Now, my problem : > > > I have, from a friend of mine a K2, #4895, who is not playing his part!!! > It come from South Pacific (French Polynesie) and the problem is manifest > with, mainly, no frequency display. > As I have another K2, I canibalized it to test the first. > -1/ I exchanged the control bord and everything is OK. > -2/ Next I put back in the Control Board and exchanged the µcontroler U1. > Identical results, no frequency display. I did check the U1 pin voltage, and > they seem OK. > -3/ I put back the µcontroler and exchanged the RF board µcontroler. No > changes the same result as the #2. I also dis check voltages on this RF > Board U1, and they look OK too. > Then, with my small digital scope, I tried to see the AuxBus signals, on the > Contro Board U1 and on the RF Board U1 too. > They look OK for me, but it's subjectif as I do not have the timing of the > µcontroler from the Control Board. > The frequency display give you either 0.000.00 or 15.999.99 dependign on the > band (but you do not know on wich band you are!) > But I ear the relais working each time I push Band+ or Band-. All other > functions seems to work. I'm able to set up the SMeter low and high values, > Mode change as it should, > All Menu functions come up and display correctly. > By the way, the curent is normal (13.9 V, 0.32 with only the NB in place). > The PA is dead, one 2sc1969 is open! > > So, have you Waine or other people, any idea about what I should check? > > Beside that I would like to order : > > 3 PA kits or 6 2sc1969 (E580008), > 6 chassis fastener (E100078) > > Just email me the amount for these parts and I will pay you as I always did. > I by your intervention I need some other part, I will then make another > order. > > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html