Fred, Look carefully, that new manual does not match your KSB2. Yours has an SSM2165 Speech Compressor and the new one uses an SSM2166 - the added resistors support that new IC.
As far as the extra 10k resistor, one is supplied with every KSB2 for use as a bias resistor if needed. It is listed in the parts list as a component on the front panel. 73, Don W3FPR On 8/1/2012 3:30 PM, KC9QQ wrote: > I am currently in the process of assembly a KSB2 (REV E KSB2 PC Board) which > I purchased with my K2 in November 2011. I am currently completing the > installation of the resistors on the back side of the board. After I > completed installing the resistors I noticed that I had an extra 10K > resistor. I then checked my inventory and it showed that I had inventoried > 3 10K resistors versus the 2 called for in inventory sheet. > > Just to be safe I downloaded the latest manual and compared it to my manual. > It lists an additional four resistors on the back of the board (R21, R22, > R23 and R24). > > I have two questions: > > 1. Should I be concerned that these resistors are not on the Rev E board? > > 2. What is the purpose of the additional resistors? > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html