Steve Hostetler wrote:
You can cut the LEDs using a very fine tooth straight-back saw you can
buy for a few bucks at your local hobby shop. They cut easily and
cleanly. The back light is an elegant and much appreciated addition
to the K1.
steve, kx7r
A Dremel with a cutting disk makes short work of it. The light works
great.
Or, if you're lazy like me, the backlight as supplied fits just nicely
when you place the right hand side against the leads of the capacitor
(C4?) on the board. Works great and looks great too!
72,
Joe, W2RBA
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
