How did you program the memories Mike? Using the K3 Memory Utility, I
put the CW [channel centered] frequency in VFO A, and the SSB [offset]
frequency in VFO B for each of the five channels [51-55 for me] and made
them frequency hoppers. The K3 scans on VFO A [CW], but it doesn't seem
to matter, if there is activity there, it stops and a single A/B tap
changes to SSB on the same channel. Works for me.
73,
Fred K6DGW
- Northern California Contest Club
- CU in the 2013 Cal QSO Party 5-6 Oct 2013
- www.cqp.org
On 12/28/2012 2:20 PM, Mike Herr wrote:
I have programed in the CW and SSB freqs for 60 meters into the
memories. If I directly access the memories I get the proper
frequencies and modes. But if I set for frequency hopping it starts in
CW mode and stays in CW, regardless of frequency. So I end up scanning
all the freqs in the CW mode. Any thought on forcing the proper mode?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
