paul ecker <ecke...@yahoo.com> wrote: >I cannot get the K3 scanning function >to work properly. I am following the instructions in the K3 manual pg >40 >as well as the Fred Cady book pg. 46. I have used both the Elecraft K3 >Memory Editor >and entered the memories manually, to save the frequencies into the K3 >memories. When I press M>V, the freqs stored in memory are only being >recalled to VFO A but not to VFO B. So when I press Scan, no scan >commences. If >I program the desired freqs into VFO A & VFO B manually, and then press >Scan, I get M>V REQ in the display window and no scan start. I have put >the lower start freq >in VFO A and the Stop in VFO B. I have also saved the desired mode with >each >memory pair. > > >So obviously I am missing something in >this process but it’s not apparent to me in the manual nor could I find >in the >archives. So what am I missing? > > >73 Paul >kc2nyu >______________________________________________________________ >Elecraft mailing list >Home: http://mailman.qth.net/mailman/listinfo/elecraft >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:Elecraft@mailman.qth.net > >This list hosted by: http://www.qsl.net >Please help support this email list: http://www.qsl.net/donate.html
I've noticed this when B is not on same band as A. Try A-B and recall your memory again -- Pierfrancesco Caci ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html