Two different animals.
Harmonics and spurs are regulated by the FCC to be at least -43dB down on HF and -60dB down on 6 meters.
The K3(s) meets those specs easily as evidenced by a couple of QST reviews.
IMD is not regulated I think because most hams don't have the test equipment to pull it off accurately.

All of this IMD hullabaloo would quickly go away if the manufacturers would switch from 12V finals to 50V finals or used pre-distortion of some sort. How much will Ham's pay to clean up the IMD problem when the FCC doesn't regulate it?


On 12/30/2015 9:09 PM, a...@sbcglobal.net wrote:
Who has some measured 2 tone IMD test figures for an actual  K3/K3S at full and 
reduced power levels and at supply voltage levels between 12-15 volts?Must 
assume the Harmonic and Spurious Outputs exceed 50dB below carrier @ 100W 
within ham bands as per Elecraft manual specs.  HOW  much better than 50dB with 
above variables is the question?   Can someone share these figures?
73,Mike  AC5P



--
R. Kevin Stover
AC0H
ARRL
FISTS #11993
SKCC #215
NAQCC #3441


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com

Reply via email to