Or these, they are good to VHF range. non inductive resistor Passive Components | Mouser But if you want something that is good to microwave, then use 4 each 200 ohms 1206 chip resistors around a panel mount female BNC connector. Works slick. Mel, K6KBE
| | | | | | | | | | | non inductive resistor Passive Components | Mouser non inductive resistor Passive Components are available at Mouser Electronics. Mouser offers inventory, pricing,... | | | | From: Walter Underwood <wun...@wunderwood.org> To: "elecraft@mailman.qth.net" <elecraft@mailman.qth.net> Sent: Tuesday, December 27, 2016 11:44 AM Subject: Re: [Elecraft] Dummy loads for dummies Ah, yes, bricks. Like these? https://www.radioshack.com/products/radioshack-100-ohm-10w-10-wirewound-resistor-2-pack# <https://www.radioshack.com/products/radioshack-100-ohm-10w-10-wirewound-resistor-2-pack#> wunder K6WRU Walter Underwood CM87wj http://observer.wunderwood.org/ (my blog) > On Dec 27, 2016, at 11:42 AM, Vic Rosenthal <k2vco....@gmail.com> wrote: > > They are undoubtedly wire-wound resistors and will have too much inductance > to work well as a dummy load. The resistance is fine. If you have an SWR > meter, check it with that. SWR below about 1.5 would mean it is usable. It > might be OK on 160 or 80 meters but not on higher bands. > > Vic 4X6GP > >> On 27 Dec 2016, at 16:43, Paul C <paul...@sbcglobal.net> wrote: >> >> I made my own dummy load last night from two 100 ohm resistors wired in >> parallel. They are rated for 10 watts each and look like little bricks. I >> measured the resistance at 51 ohms. Do you think this is close enough or >> should I reduce it to 50? >> >> Paul KG5KXG >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:Elecraft@mailman.qth.net >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> Message delivered to k2vco....@gmail.com > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to wun...@wunderwood.org ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to farrerfo...@yahoo.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com