Did you power the k3 off from the power button or by cutting power to the k3?
-------- Original message -------- From: Steve Wilson via Elecraft <elecraft@mailman.qth.net> Date: 2017-04-17 11:14 PM (GMT-05:00) To: Elecraft@mailman.qth.net Subject: [Elecraft] K3 & Heil HM-10 Dual Hi all, I setup a K3, that my godfather is borrowing, while his Kenwood is off the air. I reviewed the webpage on the Heil Sound website here: https://heilsound.com/heil-amateur-radio/support/dsp-settings/all-things-elecraft/ Unfortunately, the page refers to the mic with regard to the front panel setting, but does not specifically refer to the mic model with respect to the mic gain and mic bias settings. I sent an email to Heil Sound suggesting that the missing detail be added for this particular mic. But thought I'd ask here, in case anyone knew the answer. I deduced that the setting should be Front Panel, Low, No Bias, but am not 100% sure about that! Here's the strange part about this story. I did have a QSO with a station in North Dakota after setting up the rig, so we knew all was working. We shut off the rig and I left for home. Later in the evening, my godfather turned the K3 on and tried to transmit, but noticed that he wasn't getting any moving bars with the transmit audio. I walked him through putting the K3 into test mode, turning down the mic gain, and then turning up the mic gain while he was transmitting to find the optimum level, but we couldn't get the meter to show any response to the audio. I did the same procedure on my own K3 to make sure I was talking him through the right steps and it worked fine on mine. He did try a Heil headset with the same results. I plan to try and get up to visit again this weekend and bring a hand mic with me to try and make sure that it is definitely the K3 and not the mic. So unless I'm missing something obvious, it seems like there is an issue with the K3 itself. Unfortunately, Elecraft support couldn't go beyond the same tests that I did last night. Does anyone have any suggestions short of shipping to, or dropping off the rig, at Elecraft for a thorough test? Thanks, Steve KG6HJU ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to hlyin...@yahoo.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com