Hello All. My setup is, K3 (sn:5845), computer Athlon 2.5 GHz running WinXP, and homebrew logging program. Antennas, 40m e/f inv vee tuned through ATU on all bands, and 20/15m Bi-square coax fed into shack. Ground is 1/4 wave radials for each band, strapped together and connected to ATU, K3 grnd point and computer chassis.
Recently I've been plagued with RFI? problems. I originally ran Win98se with very few problems. I upgraded to WinXp, so I could run SDR progs that wont run on 98se. This is when the problems started. I had to rehash logging prog to get K3 Cat working. things seemed OK. I was sending a rprt on 80m CW, when suddenly calculator, win media player and internet explorer started. I was running 100w, reducing to 60w seemed to clear the problem. I decided to rebuild my CW/FSK/PTT interface, the old one was done for IC7000 with audio isolating trannies etc. The new circuit uses 3 opto-couplers, built in a small diecast box, at the moment the input serial grnd goes to input of opto's and the K3 grnd goes to output of opto's, the box is connected to station grnd. Question: A) should the serial grnd go to the box. B) should the K3 grnd go to the box. C) or should they all be connected to the box. How does this affect the isolation of input/output of opto's? Recently keying the rig from the computer, the K3 would lock up, if I keyed using paddle and K3 keyer no problem also discovered turning off K3 port on computer(no CAT to K3), no other changes, keyed OK. The K3 serial lead used an old serial mouse lead all connections at both ends. I read Jim K9YC's article on RFI and followed his suggestion, made up a new lead using 2 twisted pairs for TxD & RxD, 1 lead from each to grnd. The first time I tried this running 10w the computer switched off and rebooted. With the K3 serial lead disconnected I could run 100w no problem. I can run 100w on all bands, with full Cat to K3, on dummy load. Everytime I try something new it gets worse, more questions than answers. I've hit a brick wall. I know I need to gradually take things a step at a time, the question of the interface box is a start point. I throw myself at the mercy of the reflector, hoping the guru's can provide an answer or at least point me in the right direction. Thanks in advance Gray G3VIP ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com