Buck,
Configure PWR SET = Per Band
73 George AI4VZ
-----Original Message-----
From: Nr4c
Sent: Tuesday, January 16, 2018 10:48 PM
To: Buck
Cc: elecraft@mailman.qth.net
Subject: Re: [Elecraft] K3s - KPA500
I think you have to set the power to required setting in Operate mode the
first time. The radio will reset to full or low when amp Mode is selected
after that.
Sent from my iPhone
...nr4c. bill
On Jan 16, 2018, at 10:11 PM, Buck <radiok...@gmail.com> wrote:
Someone please help me out because I can't find the answer.
K3s and KPA500 - I know there is a setting so the K3 will know the amp is
in OPER state and automatically reduce the drive to 25 or so watts. Then
when you put the amp in STBY of OFF, the K3 will go to 100 watts.
My Amp and K3 are talking to each other for band changes etc but I can't
get the power to automatically reduce as described.
What am I missing? Point me to the page in the manual
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
