The picture was rejected. Not a problem. See if the point is said
without the "extra" 1000 words... steve
On 2/18/21 8:58 PM, stephen shearer wrote:
I have seen a difference in low end (audio bandpass) performance in
the past, it was not a problem.
I use DATA for FT8.
I have had "issues" with FOX/HOUND as the FOX is often below 400Hz.
With few DXpeditions, Fox/Hound has not been an issue.
When I have tried Winlink VARA, I have problems as it also works below
400HZ.
See: snapshot. DATA vs SSB... SSB is FLAT (0db), but note the signal
is down to ~200Hz. (you can see when I switched between SSB and DATA.
In DATA mode, it is ~350Hz (closer to 400Hz for flat data).
(assuming photo made it past email server)
Yes, I can re-set RX/TX EQ between DATA and SSB, I should not have to??
Is this an Elecraft problem with settings (firmware) or is there a
setting I missed? (to set DATA low end)...
KX3 #3819 Firmware up to date.
73, Steve WB3LGC
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
