Does the selection of encoder rates only apply to the K4? 73, Jim N7US
-----Original Message----- From: elecraft-boun...@mailman.qth.net <elecraft-boun...@mailman.qth.net> On Behalf Of Wayne Burdick Sent: Thursday, October 28, 2021 10:49 To: Elecraft Reflector <elecraft@mailman.qth.net> Subject: [Elecraft] Elecraft K-Pod manual updated -- now covers use with the K4 The K-Pod is an accessory control panel that's ideal for use with the K4. It provides 16 switch functions; control of VFO A/VFO B/RIT-XIT offset; and three general purpose open-drain outputs for station control. You can use the K4's macro editor to create command sequences to assign to K-Pod switches. For further product details, see: https://elecraft.com/collections/k-pod-desktop-control-panel Revision F of the K-Pod owner's manual now provides complete instructions for use with the K4 transceiver. The manual can be found here: https://ftp.elecraft.com/K-Pod/Manuals%20Downloads/E740285%20KPOD%20Owner's%20Manual%20Rev%20F.pdf K-Pod firmware was also recently updated: Rev. 1.12 lets you configure the K-Pod's encoder to have the same resolution as those on the K4 (up to 400 counts per turn). 73, Wayne N6KR ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
