Peter, The usual answer to that question is YES - Elecraft *usually* provides excessive wire length. If you have any doubts, just look ahead in the manual and pre-cut the wire for the toroids yet to be wound - then see if you have enough to re-wind L2. You could save enough green wire for winding T1 (the only place it is used) and use green to re-wind L2 if necessary. Other than convention, there is no magic to the wire color.
BTW - L2 will likely work just fine with the crossed wires, it is the number of times through the center of the core that count. Overlapped wires do present an aesthetics "problem", so take your pick. 73, Don W3FPR Peter N. Spotts wrote: > Hey folks, > > Just wondering if the coil of red wire for winding toroids has enough > for a rewind of L2 without eating into the supply for the remaining > toroids. I got L2 wound, and it looked good under a magnifier. But > somewhere between tinning and soldering, two windings became overlapped. > Seemed the better part of valor to unsolder and rewind. > > With best regards, > > Pete > > > ------------------------------------------------------------------------ > > > No virus found in this incoming message. > Checked by AVG - www.avg.com > Version: 8.5.423 / Virus Database: 270.14.31/2457 - Release Date: 10/24/09 > 14:31:00 > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html