Gary, Thank you very much for this information - I will give it a try. This forum is a joy as is the K3.
73 Doug EI2CN On Thu, 12 Nov 2009 08:17:27 -0500, "Steve Ellington" <n...@carolina.rr.com> wrote: > Gary: RE: Preamp ON > > I agree with your comment on the preamp even though it runs against common > knowledge. Even on 160m where the noise level is S9, sometimes I can bring > out a weak cw signal by using the preamp and with AGC settings similar to > yours. I know it doesn't make sense and I can't explain it but it works. > > Steve > N4LQ > n...@carolina.rr.com > ----- Original Message ----- > From: "Gary NL7Y" <pea...@gci.net> > To: <elecraft@mailman.qth.net> > Sent: Thursday, November 12, 2009 2:51 AM > Subject: Re: [Elecraft] [K3] K3: CW weak signal > > >> >> Low band DX from Interior Alaska are always a work in progress. Ignore > the >> howling and instead listen for the signal. It's not a wolf at the door. >> Try >> this for weak DX: >> >> 200Hz filter (or the narrowest you have) >> 6-8db filter gain (weigh S/N vs signal strength - I set mine at 8db gain >> for >> weak, lower for stronger) >> BW 100-0.50 Hz (any wider is worse for weak signals for me) >> Pre-Amp on (it does help and does not distort the signal) >> NB as required (I need DSP 2-7, IF Med-7, = 2S units lower city noise) >> AGC Threshold 006 for weak signals, 005 for stronger signals if AGC on >> AGC Slope 000, 005 for stronger signals if AGC on >> Also try AGC Off and ride the RF gain for best signal >> Adjust audio gain for minimum noise/best signal >> >> You truly haven't experienced the unique abilities of the K3 until you >> work >> Low Band DX in, or just out of the the noise floor, compared with other >> radios. It's an amazing piece of radio gear. >> >> 73 Gary NL7Y >> >> >> >> _____________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:Elecraft@mailman.qth.net >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> >> >> >> -- >> View this message in context: >> http://n2.nabble.com/K3-CW-weak-signal-tp3981344p3991230.html >> Sent from the [K3] mailing list archive at Nabble.com. >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:Elecraft@mailman.qth.net >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html > > > -------------------------------------------------------------------------------- > > > > No virus found in this incoming message. > Checked by AVG - www.avg.com > Version: 9.0.704 / Virus Database: 270.14.61/2497 - Release Date: 11/11/09 > 14:41:00 > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html