If it's not too much trouble I would support adding the package. I don't think QT is going to be a big problem. There are several work arounds that I can think of. I would think the distributions will work something out quickly enough as QT is used alot.
________________________________ From: andy pugh <[email protected]> Sent: January 22, 2021 11:43 PM To: EMC developers <[email protected]> Subject: [Emc-developers] Glade-gtk2 and Debian Buster GladeVCP and Gscreen development rely on the Glade editor, but a compatible version is not trivial to obtain on Buster. There are some instructions on the forum, but they run to two pages: https://forum.linuxcnc.org/48-gladevcp/33309-glade-3-20-will-not-work-with-linuxcnc-please-follow-this-for-3-8-6?start=10#99607 Should we consider providing a Glade 3.8.6 deb package (Like we did for Wheezy) or should we decide that Glade / Gscreen is a dead end and switch to QT[1] [1] Just in time for QT to change its licensing model.... -- atp "A motorcycle is a bicycle with a pandemonium attachment and is designed for the especial use of mechanical geniuses, daredevils and lunatics." — George Fitch, Atlanta Constitution Newspaper, 1912 _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
