On Tuesday 23 February 2021 04:12:19 Thomas J Powderly wrote: > I'm getting 73.1us base latency already > > and need about 20 for my step timings worse case, > > so 80us base thread is ng
Mine with std threads is much worse ATM, but mc is busy unpacking the src zip. And doing it over my local net. And thats seriously hogging cpu cycles. And, the pi was also busy building linuxcnc-master :) But now I have another problem. One for Peter. mesaflash can readhmid of a 5i25 just fine, well enough I can see its the wrong firmware in it, no pwmgens, but won't write a new one. Complains all the file headers are wrong: gene@Hardinge1:~/linuxcnc/hostmot2-firmware-5i25$ sudo mesaflash --device 5i25 --program prob_rfx2.PIN ERROR: Board 5I25 doesn't support FPGA resetting. gene@Hardinge1:~/linuxcnc/hostmot2-firmware-5i25$ sudo mesaflash --device 5i25 --verify prob_rfx2.PIN Checking file... Invalid bitfile header! But it doesn't look contaminated to me. What did I forget to do? Thanks Peter. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
