On Sat, 27 Feb 2021, Curtis Dutton wrote:
Date: Sat, 27 Feb 2021 08:08:49 -0500
From: Curtis Dutton <[email protected]>
Reply-To: EMC developers <[email protected]>
To: EMC developers <[email protected]>
Subject: [Emc-developers] I wish I had a super size 8i20
I've recently purchased a Fadal VMC 15 and I'll be retrofitting it and
replacing servos and electronics. The last machine I retrofitted was an old
miyano gang lathe and I'm driving the spindle and servos with 8i20's. I
just love them they are great.
Is there any plan for a larger capacity 8i20? I wish I didnt have to buy
vfd's for large spindles and could use a super size 8i20. say up to 10hp or
so.
Has this ever been discussed before?
-Curt
BTW I was looking at finally writing some driver code for the
DataPainter firmware module using hal_port. The hal_port
manual page references example code but I cant seem to find it...
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
Peter Wallace
Mesa Electronics
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
