On 22/07/2015 16:01, Russell Brown wrote: > Can I suggest adding this: > > (MSG, WARNING: This is a Demo routine. Really sure you want to run this > G-code?) > M0 > > to the top of the distributed version of axis.ngc (the 'Linuxcnc' g-code > that axis loads by default)? This might save someone some grief. > > > > > It was 100% my own stupid fault but I destroyed a touch probe last > night. > > I'd been doing some probe testing, restarted linuxcnc, got interrupted > by SWMBO, forgot to reload my test program, hit start on my pendant and > didn't hit Stop quickly enough as I watched the probe ploughed into the > top of my vice neatly crushing the body and breaking the pcb :-( > > <silverlining>Ho Hum... it was a rubbish probe anyway.</sl> > I would second this, I've had to dodge flying bits of small end mills due to the same scenario!
-- Ed Simmons e...@estechnical.co.uk http://www.estechnical.co.uk ------------------------------------------------------------------------------ _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers