On 2.8.0~pre1 (I think I get this on 2.7.14 also) any config
that accesses the parallel port produces
an error message on the Axis screen:
linux parallel port @57360 not found
57360 decimal does equal 0xe010, which is my parport
address so it is just printing it as decimal, but why does
it say "not found"?
LinuxCNC then goes ahead and works correctly. Should I
submit this as a bug?
Jon
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-developers mailing list
Emc-developers@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-developers