I recently purchased a small HMC with Fanuc control and red cap AC motors. The control and probably servo drive will go on Ebay as I have no docs with the system and it had been partly dismantled. A couple of questions, Does antone know if a VFD will work on a PM 3 phase motor as well as a squirrel cage type? That would make the spindle drive much easier. Does anyone make an amp that works well with EMC and can drive an AC servo? Motors specs are: 198V at 7.6A at stall. Jon, will your system work with this? I can change the encoders. Thanks. Ed.
------------------------------------------------------------------------- Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW! Studies have shown that voting for your favorite open source project, along with a healthy diet, reduces your potential for chronic lameness and boredom. Vote Now at http://www.sourceforge.net/community/cca08 _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
