Have you tried: sudo apt --fix-broken install ?
On Tuesday, November 7, 2023 at 09:27:56 AM EST, fxkl47BF--- via Emc-users
<[email protected]> wrote:
i have two systems i use to run linuxcnc sim
both are debian 11, bullseye
i installed linuxcnc 2.9 on both and it worked perfectly
last night i ran apt update, apt upgrade on one system
it broke linuxcnc and it can't be installed
# apt install linuxcnc-uspace
Reading package lists... Done
Building dependency tree... Done
Reading state information... Done
Some packages could not be installed. This may mean that you have
requested an impossible situation or if you are using the unstable
distribution that some required packages have not yet been created
or been moved out of Incoming.
The following information may help to resolve the situation:
The following packages have unmet dependencies:
libc6-dev : Depends: rpcsvc-proto but it is not installable
Breaks: libglib2.0-dev (<= 2.72.3-1) but 2.66.8-1 is to be
installed
libcurl3-gnutls : Depends: libgnutls30 (>= 3.7.5) but 3.7.1-5+deb11u3 is to
be installed
Depends: libnghttp2-14 (>= 1.50.0) but 1.43.0-1 is to be
installed
Depends: libzstd1 (>= 1.5.2) but 1.4.8+dfsg-2.1 is to be
installed
E: Unable to correct problems, you have held broken packages.
there's probably a simple fix
anyone care to share
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
