> -----Original Message----- > From: andy pugh [mailto:[email protected]] > Sent: October 1, 2025 1:44 AM > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] linuxcnc.org unrechable > > On Wed, 1 Oct 2025 at 09:15, theman whosoldtheworld > <[email protected]> wrote: > > > > .... not check linuxcnc sites from a while ... today need to see my > > old post and man9 online ... discover server seems dows .... only as > > advice > > Both the main website and forum seem OK from here. Though a lot can > change in 25 minutes. > > -- > atp
No problem here in Canada accessing the linuxcnc.org page. Can also go to the downloads page from there but then it gets curious. With all the hoopla about the 2.9.6 release the ISO that is downloadable is : LinuxCNC 2.9.4 Debian 12 Bookworm PREEMPT-RT ISO For newbies (or people who forget) it might be worthwhile putting in a quick note that says on a fresh install from this ISO then do the apt update and upgrade to get up to 2.9.6 assuming that actually would work to upgrade to 2.9.6 John _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
