I just downloaded the image from linuxcnc.org (image_2025-11-10-raspios-lcnc-2.9.7-6-trixie-arm64)
The directions say 'A setup wizard will run on startup to configure username, password, WiFi etc.' This doesn't happen. You are logged into the user 'rpi-first-boot-wizard' there seems to be a startup entry that says something about setup wizard. A little google searching says that 'piwiz' is the normal config utility. I apt-get installed it. rebooted boots to the config utility - yay! run through the config utility and reboot. It boots back into the user rpi-first-boot-wizard and runs the setup utility again. after a bit of futzing - it looks like at bootup the piwiz isn't run as sudo.. I ran it as sudo - it then re-login (I think) and it was logged in as my user I created and everything looked good Could other things. -The screen goes blank still - I don't think this should happen on a cnc machine. -the cool linuxcnc boot screen seemed to have disappeared after an apt-get update..(not 100% sure when this happened) _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
