Ok ... thanks John
-----Original Message----- From: Jeff Epler [mailto:[EMAIL PROTECTED] Sent: Thursday, October 16, 2008 8:25 AM To: Enhanced Machine Controller (EMC) Subject: Re: [Emc-users] EMC2 and the Sherline mill On Thu, Oct 16, 2008 at 04:38:09AM -0400, John Domville wrote: > No limit switches. Where do I find the "step config" ? Was that part of the > machine config > I set up originally through the config wizard? Yes. If you are using stepconf, it's the page entitled "parallel port setup". http://linuxcnc.org/docs/html/config_stepconf.html#sub:Parallel-Port-Setup Jeff ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users