Den tis 17 juli 2018 16:00Gene Heskett <ghesk...@shentel.net> > > <https://plus.google.com/+FrankHerrmann1967/posts/bYGRKJ7MLJo> > > This link from one of the comments shows a considerably better idea, but > their demo video is obviously being done by hand as all the intermittent > motion could well be converted to gcode and done in 2% of the time. > Another item would be to reverse the motor depending on the pocket being > addressed as that would allow bigger gears at the expense of needing to > invert the motor drive, needed for adequate tightening of the collets. > Proof of concept, but needs more development. And again, skips the > drawbar problem. > > -- > Cheers, Gene Heskett > -- >
Oh, that was a neat solution! I was thinking of a modified version of the xatc but with the "ratchet" as a separate tool. But this one I will steal some ideas from for sure. I think I use the same concept but the wrench will sit on the ATC, not on the spindle. Good find Gene! /Sven > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
