Without I3.00 make no difference.
Then there is G33.1 in the file error message "parse_file interp_error"
is shown and display is not updated.
Looking more closely at the bottom G-code is however actually loaded and
seems to execute correct including the G33.1 rigid tapping cycle even
though there is error message and display not updated.
Nicklas Karlsson
Den 2023-06-14 kl. 21:36, skrev Sam Sokolik:
Could you try it without I3.000?
On Wed, Jun 14, 2023 at 2:31 PM John Dammeyer <jo...@autoartisans.com>
wrote:
Does your spindle have an encoder and the spindle at speed?
https://forum.linuxcnc.org/38-general-linuxcnc-questions/43124-g33-1-rigid-tapping
-----Original Message-----
From: Nicklas SB Karlsson [mailto:n...@nksb.eu]
Sent: June 14, 2023 12:14 PM
To: emc-users@lists.sourceforge.net
Subject: [Emc-users] G33.1 error then g-code file parsed
I put the lines below into a file:
� M3 S100
� G33.1 Z-30.474 K0.8 I3.000
� M5
� M2
Then I read into Linuxcnc I get error message:
� parse_file interp_error
Removing the line with G33.1 then no error message so it is something
with this row. Program do however execute as expected with G33.1 line
even though there is an error message so no real problem. Also execute
without an error message if run manually in MDI mode. Use origin/master
last commit Mon May 8 16:10:03 2023 +0200
404aa407f136ce91a3e6bf911c7bda54011a74e9 Anybody else had similar problem?
Nicklas Karlsson
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
